| Site Navigation |
|---|
|
|
| Builders Networks |
| RV Builders IM Network |
| Van's Airforce (RV-10) |
| Matronics Lists |
| Micellaneous Links |
| Van's Aircraft |
| Avery Tools |
| AOPA |
| EAA |
| EAA Chapter 79 |
| Aircraft Spruce |
June 12, 2004
All done! The bracket is finally riveted (yesterday), and I riveted the 9 countersunk holes on each of the flanges. Only had to drill out one bad rivet where I didn't hold the squeezer absolutely perpendicular. Oh well, as I told the kids, if I tried to claim I didn't make any mistakes, nobody would believe I built the damn thing!
HS1004...you start off by grabbing 4 of them. All four will be modified a little bit, 2 each the same way.
First step was to remove the section of the flange up to the relief hole (this is in all 4 pieces). In the picture above this one, the relief hole is on the left...obviously this is shot from the other side because here it was on the right.
Now you take 2 of the HS1004's, and remove the tab on the other side.
